That’s where I’m going to end this video. Remember that if you do this once, you can double click every time afterword to repeat the tool’s last action. Once you draw your doors on your walls, you can use the push/pull tool to push them until they hit the other side of the wall, where SketchUp will automatically delete the faces. When I did this, it seemed much easier than doing it the other way. This can be handled fairly easily with guides. This is a much easier way to do this, because you aren’t dealing with the healing, but you’ll have to go in and add all your door locations after the fact. You can also extrude your walls, then add your doors. However, if you want actual door openings, you’ll have to come in, model the tops of the doors, and deal with SketchUp autohealing over and over again. This has the benefit of making it so your doors are in the right place before you extrude. The first is to just rough out your door openings before you extrude your walls. There’s a couple ways you can do this, and I’ll run through the pros/cons of each. The tricky part is how to include your doors. Once you’ve roughed in all your walls, you can go in, do a little cleanup to make sure your walls are continuous faces, and then use push/pull to extrude your walls into 3d. In this case, I’m going to assume my walls are 6” thick. You can do that by activating the tool, then clicking in a space, then entering the thickness you’d like to offset your space. Once you have your spaces roughed out, you can go in with the offset tool and create your walls. There are several different ways you can go about this, depending on if you’re creating a new floor plan, or if you have and existing floor plan image that you’re bringing into SketchUp in order to model it in 3D.Ĭreating a floor plan from scratch in SketchUp is pretty easy – you can start off by drawing the outline of your space in 2D, then you can use rectangles to rough out your spaces. In this week’s SketchUp tutorial, we’re going to talk about creating floor plans in SketchUp Part 2 will focus on modeling a floor plan from an image. Use the corners to make it larger or smaller, wider or thinner.Part 1 of this 2 part series will focus on using the line and offset tools to create a floor plan in SketchUp. If the door from Warehouse doesn't fit, select it by right clicking, go to tools, and click scale. Note: If your door was already made, you have to do this with the interior line and the exterior line.Īfterward, get a door from the 3D warehouse to go over it, or just leave it open. Get the four way arrow tool, click the red line (according to the picture) select the line you want to move, and move it in or out. Next, if you want it wider or thinner, get it in the angle of picture 3. Get a square that connects all four, and pull it closer to the ground. Find a space where you can see all four corners that are above the doorway. Next, get it at an angle as you see in picture two. Next, Raise the larger portion of the section to ten feet, while keeping the space for door at no elevation. If this sentence seems akward, there is a picture for your help. Picture 1įirst, take your square that was made, and then use the square tool to make a smaller square when you want the door.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |